MakerPulseV2

by The Young Maker

Set up your MakerPulseV2 "Cheap Yellow Display" desk companion straight from this page — no Arduino IDE, no cables to a laptop full of toolchains, just a browser.

Preview build. The Home screen has the new "Colourway" look end to end; Weather, Bus, and Status have the new colors and typography but still share layout with the original MakerPulse. Expect rough edges.
This flashing tool uses WebSerial, which only works in Chrome or Edge on desktop (Windows, macOS, Linux) — not Firefox, Safari, or any mobile browser.
1

Plug it in

Connect your MakerPulseV2 to this computer with a USB cable.

2

Connect and flash

Click the button below, pick the device's serial port, and wait for flashing to finish.

3

Join your WiFi

A WiFi setup dialog appears automatically right after flashing — no re-flash needed if you ever switch networks.

4

Cable on the bottom?

Every MakerPulseV2 runs the same firmware. If your USB cable comes out of the bottom edge instead of the top, open your device's own Settings page (shown on-screen once WiFi is connected) and switch "Screen orientation" to "USB on bottom" — no re-flash needed.

Your browser does not support Web Serial. Please use Chrome or Edge on desktop. This site must be served over HTTPS to flash devices.

Already flashed and just need to reconnect to a new WiFi network? Click the button above again — it detects your device and offers WiFi setup directly, no re-flash needed.